{"id":3651,"date":"2021-06-15T20:29:06","date_gmt":"2021-06-15T20:29:06","guid":{"rendered":"https:\/\/www.dynamism.com\/learn\/?p=3651"},"modified":"2021-09-21T17:44:46","modified_gmt":"2021-09-21T17:44:46","slug":"removing-prints-from-ultimaker","status":"publish","type":"post","link":"https:\/\/www.dynamism.com\/learn\/3d-printing\/removing-prints-from-ultimaker.html","title":{"rendered":"Removing Prints From Ultimaker"},"content":{"rendered":"\n
\n
\n
\n
\n

Print Removal Techniques<\/h2>\n\n\n\n

After your print has completed, it will need to removed from the glass build plate. There are a few separate techniques to accomplish this, and each can have advantages depending on the specific part and whether any additional adhesives were used.<\/p>\n\n\n\n

\n\n\n\n
\n
\n
\n
\n

Wait For the Glass Plate to Cool Down<\/h2>\n\n\n\n

If you printed directly on to the glass plate without using an adhesive, and if the build plate was not leveled too tightly, the print may easily be removed once it is cool. Simply allow the build plate and the print to cool down after printing. The material will contract as it cools and you can easily remove the print from the build plate.<\/p>\n<\/div>\n\n\n\n

\n
\"\"<\/figure><\/div>\n<\/div>\n<\/div>\n\n\n\n
\n\n\n\n
\n
\n
\n
\n

Use a Spatula or Scraper<\/h2>\n\n\n\n

If your print doesn\u2019t remove from the build plate after cooling, you can use a spatula to remove the print. Place the spatula under the print and apply a small amount of force to remove the print.<\/p>\n\n\n\n

NOTE:<\/strong>\u00a0Take the glass plate out of the printer to avoid damaging the build plate clamps.<\/p>\n<\/div>\n\n\n\n

\n
\"\"<\/figure>\n<\/div>\n<\/div>\n<\/div>\n<\/div>\n\n\n\n
\n\n\n\n
\n
\n
\n
\n

Use Water to Remove the Print<\/h2>\n\n\n\n

If neither of these methods work, remove the print using water. Remove the glass plate and print from the Ultimaker. Be careful not to burn your fingers if the glass plate is still warm. Run cool tap water on the backside of the plate to cool it quicker \u2013 the print material will contract more than during a normal cool down. Once the plate has cooled, the print can be popped off.<\/p>\n\n\n\n

If glue or Magigoo was used on the glass plate, run lukewarm water over the print side of the plate to dissolve the glue. Once the glue has dissolved, it should be easier to remove the print. If PVA was used, place the glass plate and print in water to dissolve the PVA \u2013 this makes print removal easier.<\/p>\n<\/div>\n\n\n\n

\n
\"\"<\/figure>\n<\/div>\n<\/div>\n<\/div>\n<\/div>\n<\/div>\n<\/div>\n<\/div>\n\n\n\n
\n

Quick Links<\/h2>\n\n\n\n