Material Station and Air Manager Installation
Material Station Installation
Mount the Ultimaker S5 to the Material Station
01
Carefully place the Ultimaker S5 on top of the Material Station
02
Insert a tube coupling collet in the bottom of each feeder of the Ultimaker S5
03
Insert the left Bowden tube of the Material Station into the left feeder, and the right Bowden tube into the right feeder
04
Secure the Bowden tubes with clamp clips
05
Place the spool holder cap into the hole of the Ultimaker S5’s spool holder
Air Manager Installation
Mount the Air Manager on the Ultimaker S5
01
Align the mounting bracket with the back of the Ultimaker S5
02
Guide the Bowden tubes and print head cable into both mounting bracket slots. Above feeder 2, make sure that the Bowden tube is placed in front of the print head cable
03
Gently push down on the mounting bracket until it clicks firmly into place
04
Align the bottom of the filter housing with the slots in the mounting bracket and push it into place
05
Gently push the filter completely into the filter housing
06
From the front of the printer, place the cover over the filter housing
07
Align the hinges with the mounting bracket and drop the cover into place
Plugin the connectors
01
Connect the Air Manager cable to the port at the back of the Air Manager
02
mounting bracket around the Air Manager cable and close it
03
Slide the stress relief clip upwards until it cannot go further to secure the cable in place
04
Connect the other side of the Air Manager cable to the UMB OUT port on the Material Station
05
Connect the Material Station cable to the UMB IN port on the Material Station and the other end to the UMB OUT port on the Ultimaker S5
06
Connect the power extension cable to the Ultimaker S5 and the Material Station
07
Connect the power cable to the Material Station and the other end to a power outlet
